Magnet overhead crane with carrier beam introduction:
This crane is a special product equipped with electromagnetic chuck that used to lift iron or steel blocks, cylinders and so on. It consists of bridge, crane travelling mechanism, trolley, electric equipment and electromagnetic chuck. Magnetic retentive is 10 minutes after power shut. The shape of electromagnet can be designed according to adsorptive goods.
Magnet overhead crane with carrier beam technial parameters:
Capacity 10+10/5t
Crane duty class
A5~A6
Hoist duty class
M5
Lifting height
m
4,6,9,12,18,24,30
Speed
Lifting V1
m/min
4
Lifting V2
4/1
Lifting V3
4/0.4
Cross traveling V
10; 20; 25; 32; 40
Crane traveling V
20; 25; 32; 40; 50; 63; 80
Wheel Load
Max
KN
51.7
55.8
59.3
63.4
67.4
70.8
74.9
79.0
83.2
Minimum
6.2
8.2
10.6
13.9
17.5
20.5
24.4
28.0
32.4
Power
3 phase 380V-420V or on request
Magnetic chuck: Lifting Magnet Series MW5 is used for lifting and transporting steel scraps. It is suitable for transferring cast ingots and various kinds of steel scraps. It has huge magnetic force and can attract lots of steel scraps at one time. The trolley is designed to have slewing mechanism. So the lifted steel bar can change direction freely.
Motor: Drive motor must use China Top Brand. Insulation class is above F; Protective class more than IP54.
Electric system:We could offer the top brand of Electric parts such as: Chint, Siemens,Schneider and so on.
Control panel: 3 ways are optional based on budget or need: Cabin with joystick panel, wireless control panel or pendent control panel.
Painting: All steel is treated by sand blasting before doing paintings. There are 3 layers of paintings. The bottom layer is zinc painting to prevent from rusting. The color of top surface should be average.
Limit switch for safety: mechanical limit switch: overload limit, height limit, rail end stop limit for traveling. Electric protection: short circuit protection, lose phase protection, low-voltage protection, power failure protection, over current protection.
